Advanced Portable Technologies (1994) Ltd.

Skip to navigation

Configure LCP Echo

Axesstel™ AXW-D800 Technical Bulletins

Process

  1. From the Start Button click Run
  2. Enter telnet 192.168.0.1 (i.e. the IP address of the Axesstel unit) then click OK
  3. From the login screen enter the password (default is admin)
  4. Run the program sysconf2
  5. Select 5. Advanced Setup from menu
  6. Select 5. PPP/LCP Parameters from sub menu
  7. In View mode the current settings are displayed.
  8. Press enter to return to the menu and change to Set mode by pressing c
  9. Select 5. PPP/LCP Parameters
  10. Enter the required parameters (See notes below)
  11. Press s to save configuration
  12. Change to View mode by pressing c
  13. Select 5. PPP/LCP Parameters to view and confirm the rules, press enter to return to the menu
  14. Press b to return to the main menu
  15. Press q to quit back to the command line
  16. Type reboot to restart the unit and enable the LCP feature
  17. Close the Telnet window by clicking the X in the top-right corner of the window

Notes

  • lcp-echo-failure and lcp-echo-interval are the only settings that should normally be adjusted.
  • lcp-max-configure, lcp-max-failure and lcp-max-terminate may need to be adjusted in areas that suffer high disconnection rates. Please Contact us to discuss alternatives before adjusting these settings
  • debug nDescription: Enables connection debugging facilities. Only to be used in conjunction with an APT Support Technician. Default: 0 (Disabled)
  • lcp-echo-failure nWill presume the peer to be dead if n echo-requests are sent without receiving a valid echo-reply. If this count is exceeded the connection will be re-established. Default: 2
  • lcp-echo-interval n
    Send an LCP echo-request to the peer every n seconds. Normally the peer should respond to the echo-request by sending an echo-reply. Default: 7200 (2 hours)
  • lcp-max-configure n
    Set the maximum number of LCP configure-request transmissions to n. Default: 5
  • lcp-max-failure n
    Set the maximum number of LCP configure-NAKs returned before starting to send configure-Rejects instead to n. Default: 5
  • lcp-max-terminate n
    Set the maximum number of LCP terminate-request transmissions to n. Default: 2

© Copyright 1994-2009 Advanced Portable Technologies (1994) Ltd. All Rights Reserved.